In this video I’m taking a look at the Vevor 6" ventilation fan (model BTF116A) and why I’m planning to use it in my laser engraving room. It’s a budget-friendly way to move air, and it comes with an AC cord, a speed control knob, a manual, mounting hardware, and straps so you can hang it from the ceiling. I like that it has a clear airflow direction marking, a flat mounting plate if you want to hard-mount it, and an all-metal impeller inside a thick plastic housing. I plugged it in to see how it feels in real use, and it’s honestly blowing pretty strong while staying decently quiet with very little vibration. One thing to note: on my unit it starts on the highest setting and then turns down toward low. I also ran it on a kilowatt meter—high was hovering around 76W and low was around 63–64W, and I even saw a small 1–1.2W draw when it was “off,” which was interesting. My plan is a 6" trunk line outside with 4" drops to different machines, and I’ll be dialing in the lowest quiet setting that still pulls fumes out effectively.