In this video I unbox and properly test the Resiners G3 2‑in‑1 Resin Curing Machine, but not in a vague “ooh shiny gadget” way. I set myself one very specific mission: make a resin bloom inside a skull mould and see if curing in the G3 actually helps the bloom open better. Not to rescue a failed bloom, not because anything went wrong—just a proper little experiment, because blooms are fussy and they care a lot about temperature, timing, and whatever the room feels like doing that day. I take you through the unboxing and setup, then I show the exact settings I use for epoxy resin and run the bloom through the controlled curing process. The whole point is to remove some of the environmental chaos and see if that changes how the bloom forms and spreads. You’ll get the final reveal plus my honest thoughts on whether the G3 made a noticeable difference for blooming—because if you’re going to invest in a curing machine, it needs to do more than just look tidy on the desk.