I'm Taking My Workshop Offgrid Using EcoFlow Power Kits

In this video, I unbox the new EcoFlow Power Kits system and use it to take my workshop off-gird, allowing me to run my lights, laser cutter and 3D printers overnight using the solar power generated during the day. ADDITIONAL INFORMATION --------------------------------------------------- Get your own EcoFlow Power Kits system - https://bit.ly/3SlCTyn The system shown in this video is the Independence Kit (2kWh) Visit EcoFlow's Amazon Store: Independence Power Kits - https://amzn.to/3BCuFeK Prepared Power Kits - https://amzn.to/3DMtHis Visit EcoFlow's website for more information on the system - https://bit.ly/3riXDvv Visit my blog for my written unboxing and review - https://www.the-diy-life.com/taking-my-workshop-offgrid-using-ecoflow-power-kits/ MY WORKSHOP EQUIPMENT --------------------------------------------------- Gweike Cloud laser - https://bit.ly/3qbXvNx Creality Ender 3 S1 Pro 3D Printer - https://amzn.to/39lxlTX TS100 Soldering Iron - https://amzn.to/3vw6MDo Creality Ender 3 V2 - https://amzn.to/3EPQZBQ Some of the above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, at no additional cost to you. CHAPTERS --------------------------------------------------- 0:00 Intro 0:43 Unboxing The Power Kits System 4:17 Workbench Test Setup 8:31 Workshop Installation 9:35 Setup Through The App 10:36 Load Test 12:44 Final Thoughts If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.