Never use Arrma Body Clips again! Finally a TANK SOLUTION - More MOD Install tips

Better than Arrma body clips and proline screw caps! For extreme bashing and capable of handling the heavy duty basherbodies or indestructible body’s! You can go 2 inch, or 1 1/2”, one utilizes more spring, but stands a little taller and suggest a pad be put in the cap section of the body. Well, the other is more into the stock height. Your call. Ive yet to come close to bending my 2 inch set up. It’s totally tank thus far. But I will report if any changes. If you choose 2 inch, I recommend some padding in the upper cab so the cage gets utilized. In either case, I definitely recommend the basherbody. This mod was specifically inspired to accommodate to handle the Basher body. But is also totally great for the stock shell as well. If planning to just run the stock, thin body with no durability modifications I recommend 1 1/2 inches thumb screws,, and definitely utilizing the rubber washers the longer 2 inch thumb screws, link below (couldn’t find on Amazon) THE PARTS YOU NEED Note: if you go with 1 1/2 thumb screws, grab the 10mm tall springs if you go with 2" thum screws (like mine) grab the 20mm tall springs Mod parts (1 1/2 thumb screws etc) EastTactics Storefront (see mods section) https://amzn.to/4mQsGsK Pick up a Basherbody https://www.basherbodies.com M2C body mounts and basherbodies: Rear https://m2cracing.net/shop/#!/M2C-1470-LONG-BODY-POST-BASE/p/573272427 Front https://m2cracing.net/shop/#!/M2C-1469-SHORT-BODY-POST-BASE/p/573310312 Patreon (thank you): https://www.patreon.com/Easttactics?fan_landing=true Shirts https://east-tactics-shop.fourthwall.com M2C Explained Playlist: https://youtube.com/playlist?list=PL9UjUE_DygV9tVpULCnz7M6W6EYlEXd0D info@easttactics.com