Vigyata.AI
Is this your channel?

2024 Ridgeline 1st Time TRANSFER CASE DRAIN AND FILL @ 11k miles, Using Gear Oil! Easy DIY

592 views· 23 likes· 7:06· Jun 6, 2025

🛍️ Products Mentioned (3)

https://amzn.to/4jAhGxW Valvoline Gear Oil https://amzn.to/4kYhLg9 Honda gear oil https://amzn.to/4dO0VOu Fluid pump transfer Replacing the transfer case fluid in your 2021-2025 Honda Ridgeline or Pilot is a manageable DIY task that helps maintain your vehicle’s performance. Here’s a step-by-step guide to assist you: ⸻ 🛠️ Tools & Materials Needed • 3/8” drive ratchet or breaker bar • Torque wrench • Fluid pump or syringe • Oil drain pan • Clean rags or shop towels • Honda HGO-1 Hypoid Gear Oil (GL-5 75W-85) • New crush washers (optional but recommended)  ⸻ 🔧 Step-by-Step Procedure 1. Warm Up the Vehicle: Drive your Ridgeline for about 10–15 minutes to warm up the transfer case fluid, ensuring it drains more completely. 2. Locate the Transfer Case: Positioned at the rear of the transmission, the transfer case has two plugs: • Fill Plug: Located on the side. • Drain Plug: Located at the bottom.  3. Loosen the Fill Plug First: Before draining, ensure you can remove the fill plug. This step prevents situations where you can’t refill after draining.  4. Drain the Old Fluid: • Place the oil drain pan beneath the drain plug. • Remove the drain plug and allow the fluid to drain completely. • Inspect the drained fluid for any metal shavings or debris, which could indicate internal wear.   5. Reinstall the Drain Plug: • Clean the drain plug and replace the crush washer if necessary. • Torque the drain plug to the manufacturer’s specification (typically around 35 lb-ft; verify with your owner’s manual). 6. Refill with New Fluid: • Using a fluid pump, add Honda HGO-1 Hypoid Gear Oil through the fill hole until the fluid begins to seep out, indicating it’s full. • The transfer case requires approximately 0.45 quarts (about half a quart) of fluid until it pours out of fill plug 7. Reinstall the Fill Plug: • Clean the fill plug and replace the crush washer if necessary. • Torque the fill plug to the manufacturer’s specification.  8. Clean Up: • Wipe off any spilled fluid. • Properly dispose of the old fluid at a recycling center or auto parts store. ⸻ 🔁 Maintenance Interval Honda recommends changing the transfer case fluid every 30,000 miles or as indicated by the Maintenance Minder system. Regular maintenance ensures optimal performance and longevity of your vehicle’s drivetrain components.  As an amazon associate I earn on qualifying purchases ⸻

🎬 More from DIYBigGuy